Replacing soffit and fascia on a Calgary home typically costs about $8–$15 per linear foot of roof edge for aluminum, or roughly $1,500–$4,500 for a bungalow and $2,500–$6,500 for a two-storey. Expect to pay more, often an extra $15–$25 per linear foot, when rotted wood fascia has to be replaced first. Small repairs, such as a few blown-off soffit panels or one section of fascia capping, often cost a few hundred dollars.
This guide explains what soffit and fascia do, what drives the price, the signs that yours need attention, when a repair is enough, and how Calgary wind, hail and ice dams wear out the edge of a roof.
Table of Contents
- What soffit and fascia do
- Soffit and fascia replacement cost at a glance
- Cost by material
- What changes the price
- Signs your soffit or fascia needs attention
- Repair or replace?
- How Calgary weather damages the roof edge
- Wind, hail and insurance
- Why Calgary homeowners call Total Exteriors
- Frequently Asked Questions
Key Takeaways
- Aluminum soffit and fascia, the most common choice in Calgary, typically costs about $8–$15 per linear foot installed.
- Rotted wood behind the fascia is the biggest cost surprise. It has to be replaced before new capping goes on.
- Blocked or missing soffit vents can contribute to attic frost, attic rain and ice dams in a Calgary winter.
- Isolated damage can be repaired. Widespread rot, several damaged sides or a planned roof or eavestrough replacement usually point to full replacement.
- Wind and hail damage is often insurable; rot and wear and tear usually are not.
What soffit and fascia do
Fascia is the vertical board that runs along the edge of the roof. Your eavestroughs are fastened to it, and on most Calgary homes the wood fascia board is wrapped in aluminum capping so it never needs paint. Soffit is the panel on the underside of the roof overhang, between the fascia and the wall. Most soffit is vented, letting outside air into the attic so heat and moisture can escape through the roof vents.
Together they close off the roof edge from weather, birds and insects, carry the eavestroughs and keep the attic breathing. When they fail, the problems often show up somewhere else first: sagging eavestroughs, frost in the attic or water stains on a ceiling. Our article on attic rain in Calgary explains how poor attic ventilation turns into drips during a chinook.
Soffit and fascia replacement cost at a glance
Soffit and fascia are priced by the linear foot of roof edge. A typical bungalow has about 140–180 linear feet; a two-storey usually has about 180–240.
| Job | Typical Calgary cost (2026) | Notes |
|---|---|---|
| Aluminum soffit and fascia, installed | $8–$15 per linear foot | Most common choice; prefinished, vented or solid soffit |
| Replace rotted wood fascia first | Add about $15–$25 per linear foot | New lumber goes on before the aluminum capping |
| Small repair (a few soffit panels or a short fascia section) | About $200–$1,200 | Height, access and colour matching move the price |
| Bungalow, full roof edge | $1,500–$4,500 | About 140–180 linear feet |
| Two-storey, full roof edge | $2,500–$6,500 | About 180–240 linear feet; scaffolding or lifts on high sections |
| Large or multi-gable home | $6,500+ | More corners, returns and height |
Estimate ranges only, and not a quote. The real number depends on the condition of the wood behind the capping, which nobody can see until the old material comes off.
Cost by material
Aluminum
Prefinished aluminum is the standard on Calgary homes. Vented soffit panels and formed fascia capping come in a wide range of colours, do not rot and need little more than an occasional wash. Thin aluminum does dent in hail and can be peeled back by strong wind if it is poorly fastened. Well-installed aluminum and vinyl soffit can last about 20–30 years with basic maintenance.
Vinyl
Vinyl soffit costs a little less than aluminum and will not dent. It is less rigid, can sag over long spans and becomes more brittle in deep cold, so it is less common on Calgary rooflines than aluminum.
Wood
Painted wood soffit and fascia appear on many older Calgary homes and some custom builds. Wood looks good but needs regular painting, and once moisture gets in it rots. Unprotected wood often needs attention every 10–15 years. Replacing wood soffit with aluminum is one of the most common upgrades we price.
Fibre cement
Fibre cement soffit and trim boards suit homes with Hardie board siding. They cost more than aluminum and need painting or a factory finish, but they are rigid and non-combustible. If you are re-siding at the same time, see our siding cost guide for how the whole exterior adds up.
What changes the price
- Linear footage and height. More roof edge costs more, and second-storey or walkout sections need scaffolding or a lift.
- The wood behind the capping. Soft fascia boards, rotten sub-fascia or damaged rafter tails have to be repaired first.
- Eavestroughs. They have to come off to replace fascia properly. Re-hanging the old ones or installing new ones changes the total.
- Roofline complexity. Gables, dormers, returns and bump-outs mean more cuts and more corners.
- Venting. Switching from solid to vented soffit, or opening up blocked vents, is extra work but often worth it for the attic.
- Bundling. Doing soffit, fascia and eavestroughs with a roof replacement shares set-up and access costs.
Not sure what is behind your fascia? Total Exteriors can inspect the roof edge, photograph the damage and give you a written quote for repair or replacement. Call (403) 313-4932 or contact us online.
Signs your soffit or fascia needs attention
- Soffit panels that are loose, bent, hanging or missing after a windstorm
- Fascia capping that is dented, lifted or peeling back at the corners
- Soft, swollen or rotting wood behind the eavestrough, or peeling paint on wood fascia
- Eavestroughs pulling away from the house because the fascia no longer holds the fasteners
- Birds, wasps or squirrels getting into the roof space through gaps
- Frost or moisture in the attic in winter, which can point to blocked soffit vents
- Heavy icicles and ice build-up along the eaves after a chinook
Eavestrough problems and fascia problems often travel together. If your troughs are leaking or sagging too, read our guide to eavestrough replacement in Calgary.
Repair or replace?
Repair makes sense when the damage is isolated: a few soffit panels blown out by wind, one dented run of fascia capping, or a single section of rotted board. The rest of the roof edge should be sound, and the colour should still be available or close enough to match.
Replacement is usually better value when rot shows up in several places, damage covers more than one side of the house, the soffit is old wood or unvented, or you are already replacing the roof or eavestroughs. Doing the whole edge once avoids paying for ladders and set-up twice. Our soffit and fascia service page explains how we approach both.
How Calgary weather damages the roof edge
Chinooks and ice dams. A chinook can melt snow on the roof in an afternoon. The water runs to the cold eaves and refreezes overnight, building ice that adds weight to eavestroughs and can push water back under shingles and into fascia and soffit. Our guide on preventing ice dams in Calgary covers the attic side of the problem.
Wind. Strong gusts catch loose soffit panels and fascia capping and peel them back. Homes west of the city in Cochrane, and acreages across Rocky View County, see the strongest westerly winds.
Hail. Aluminum fascia and eavestroughs are soft metal, so they often show hail dents first. Dents on the roof edge are a useful clue that the shingles and siding should be checked too.
Wind, hail and insurance
If a windstorm or hailstorm damaged your soffit or fascia, the repair may be covered by your home insurance, less your deductible. Rot, peeling paint and general wear are usually treated as maintenance. Take photos as soon as it is safe, and check your policy wording with your insurer or broker.
Our HAAG-certified inspectors document roof edge damage alongside the roof and siding, which is how adjusters usually look at a storm claim. See wind damage repair, hail damage repair and our insurance claims process.
Why Calgary homeowners call Total Exteriors
Total Exteriors has repaired and replaced soffit, fascia and eavestroughs on Calgary-area homes since 2016, and we have been BBB accredited since 2017 with an A+ rating. Because we are a roofing company too, we check the shingles, drip edge and attic ventilation that the roof edge connects to, not just the panels you can see.
We work throughout Calgary and in Airdrie, Cochrane, Chestermere, Crossfield, Irricana, Beiseker and Rocky View County. See our eavestrough, soffit and fascia services for the full roof edge.
Soffit hanging or fascia rotting? Get it fixed before winter. Call Total Exteriors at (403) 313-4932 or contact us online to book an inspection.
Conclusion
Soffit and fascia replacement in Calgary usually costs about $8–$15 per linear foot for aluminum, which keeps most homes in the low-to-mid thousands. The variable is the wood underneath: sound boards keep the job simple, while rot adds carpentry. Fix isolated damage early, replace the whole edge when the problems are widespread, and pair the work with a roof or eavestrough replacement when you can.
Frequently Asked Questions
How much does soffit and fascia replacement cost in Calgary?
Aluminum soffit and fascia typically costs about $8 to $15 per linear foot of roof edge installed. That is roughly $1,500 to $4,500 for a bungalow and $2,500 to $6,500 for a two-storey home. Replacing rotted wood fascia first can add about $15 to $25 per linear foot.
What is the difference between soffit and fascia?
Fascia is the vertical board along the edge of the roof that the eavestrough attaches to. Soffit is the panel on the underside of the roof overhang, and it is usually vented so outside air can flow into the attic.
Can you replace just the soffit or one section of fascia?
Yes. If damage is limited to a few soffit panels or one run of fascia, those pieces can be replaced on their own. Older or faded colours can be hard to match exactly, so some homeowners choose to redo a full side of the house.
Should I replace soffit and fascia when I replace my roof or eavestroughs?
It often makes sense. The eavestroughs have to come off to replace fascia properly, and doing the whole roof edge at once shares the set-up, ladders and scaffolding instead of paying for them twice.
Does home insurance cover soffit and fascia damage?
Damage from a sudden insured event such as a windstorm or hail is often covered, depending on your policy and deductible. Rot and wear and tear are usually treated as maintenance. Check your policy with your insurer or broker.
Sources: RenoQuotes, Soffit: the Installation Cost; Rollex, Cost to Replace Fascia and Soffit. Prices are typical ranges that vary by home, not Total Exteriors quotes.
